DCPPE-200 過去問題、DCPPE-200 日本語版復習指南
あなたは君の初めてのDellのDCPPE-200 過去問題認定試験を受ける時に認定試験に合格したいか。ShikenPASSでは、私たちは君のすべての夢を叶えさせて、君の最も早い時間でDellのDCPPE-200 過去問題認定試験に合格するということを保証します。ShikenPASSのDellのDCPPE-200 過去問題試験トレーニング資料は豊富な経験を持っているIT専門家が研究したもので、問題と解答が緊密に結んでいるものです。ShikenPASSを選ぶなら、絶対に後悔させません。
もし君がDellのDCPPE-200 過去問題に参加すれば、良い学習のツルを選ぶすべきです。DellのDCPPE-200 過去問題認定試験はIT業界の中でとても重要な認証試験で、合格するために良い訓練方法で準備をしなければなりません。。
試験番号：DCPPE-200試験科目：「Dell PowerEdge Professional」
一年間無料で問題集をアップデートするサービスを提供いたします
最近更新時間：2017-09-17
問題と解答：全65問 DCPPE-200 ファンデーション
NO.1 An engineer is migrating an existing server node from an M1000E to a VRTX chassis.
An error message appears during POST. The system will continue to boot, but can NOT see any of the
chassis shared storage or PCle devices mapped to the server slot.
The engineer has already removed the original fabric interfaces in mezzanine slot Band C from the
original system configuration .
Which action must the engineer complete to allow the node to see chassis storage and mapped PCle
devices?
A. Remap chassis storage/PCle devices
B. Update the CPLD firmware version
C. Enable PCle Pass-Through in System Setup
D. Install PCle Pass-Through mezzanine cards
Answer: C
DCPPE-200 独学 DCPPE-200 準備
NO.2 In VRTX the following features are enabled:
1 . Server Module Firmware Update
2 . Remote syslog
3 . iDRAC Single Sign-on.
4 . Server configuration
5 . Chassis grouping
6 . Enclosure level backup
Which license type is required?
A. CMC enterprise license
B. iDRAC enterprise license
C. iDRAC express license
D. CMC express license
Answer: A
DCPPE-200 ソフト
NO.3 An engineer needs to configure server 1 to communicate on tagged VLANs 10, 20, and 30 and
untagged VLAN 50.
The server is in SLOT 1 of an FX2s chassis with two FN410s IOAs. The switches are currently set to
default settings.
Which command should be entered in each IOA to perform the engineer's task?
A. interface range vlan 10, vlan 20, vlan 30, vlan 50 no shut interface Ten GigabitEthernet 0/1
portmode hybrid switchport vlan tagged 10,20,30 vlan untagged 50
B. interface range vlan 10, vlan 20, vlan 30, vlan 50 no shut interface Ten GigabitEthernet 0/1
portmode hybrid switchport vlan tagged 10,20,30
C. interface range vlan 10, vlan 20, vlan 30, vlan 50 no shut interface Ten GigabitEthernet 0/1
switchport vlan tagged 10,20,30 default vlan-id 50
D. interface range vlan 10, vlan 20, vlan 30, vlan 50 no shut interface Ten GigabitEthernet 0/1
switchport vlan tagged 10,20,30 default vlan 50
Answer: A
DCPPE-200 体験談
NO.4 An engineer is deploying Dell SupportAssist to manage a data center.
After downloading and installing Dell OpenManage Essentials with SupportAssist, which two steps
must be done to complete this task? (Choose two.)
A. Make sure the OME server is connected to the Internet.
B. Set up iDRAC to send SNMP alerts to SupportAssist cosole.
C. Run DSET script to collect Dell SupportAssist reports for each server.
D. Set up iDRAC to send SNMP alerts to the OME console.
Answer: A,D
ShikenPASSは最新の070-774試験問題集と高品質の300-135認定試験の問題と回答を提供します。ShikenPASSの1Y0-202 VCEテストエンジンと100-105試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の70-744トレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
